Universal Serial Bus (USB) Cable and Port

Universal Serial Bus (USB) Cable and Port

Removal and Installation

1. Remove the floor console. For additional information, refer to Instrument Cluster / Carrier &/or Interior Moulding / Trim.

2. Remove the Audio Control Module (ACM). For additional information, refer to Audio Control Module (ACM) Audio Control Module (ACM).

3. Release the tabs and lower the glove compartment completely.

4. Disconnect the Universal Serial Bus (USB) cable connection at the Accessory Protocol Interface Module (APIM).

5. Remove the USB cable and port.

6. To install, reverse the removal procedure.