Crankshaft Position Sensor: Service and Repair

Crankshaft Position (CKP) Sensor













Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.

2. Remove the LH catalytic converter. For additional information, refer to Exhaust System &/or Catalytic Converter.

3. Remove the bolt, nut and the heat shield.
- To install, tighten to 10 Nm (89 lb-in).

4. Remove the rubber grommet cover.

5. Disconnect the Crankshaft Position (CKP) sensor electrical connector.

6. Remove the bolt and the CKP sensor.
- To install, tighten to 10 Nm (89 lb-in).

7. To install, reverse the removal procedure.

8. Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure following the on-screen instructions.