Wheel Speed Sensor - Rear

Wheel Speed Sensor - Rear, All Wheel Drive (AWD)









Removal and Installation

1. Remove the rear seat bolster. For additional information, refer to Seats.

2. Disconnect the wheel speed sensor electrical connector.

3. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.

4. Using a suitable tool, disconnect the grommet from the body.

5. Remove the wheel speed sensor harness nut and bolt.
- To install, tighten to 23 Nm (17 lb-ft).

6. Remove the wheel speed sensor bolt and the wheel speed sensor.
- To install, tighten to 23 Nm (17 lb-ft).

7. To install, reverse the removal procedure.