Rear Suspension

Shock Absorber









Removal and Installation

WARNING: Do not apply heat or flame to the shock absorber or strut tube. The shock absorber and strut tube are gas pressurized and could explode if heated. Failure to follow this instruction may result in serious personal injury.

WARNING: Keep all body parts clear of shock absorbers or strut rods. Shock absorbers or struts can extend unassisted. Failure to follow this instruction may result in serious personal injury.

NOTICE: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may result in major service expense. New parts must be installed with the same part numbers or equivalent part, if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these parts.

NOTICE: When using a hoist that lifts the vehicle by the frame, install new shock absorbers one at a time. If the rear axle is allowed to hang unsupported by the control arms, damage to the control arm bushings may result. A drive-on type hoist is the preferred hoist to use for this procedure.

1. Open the luggage compartment and position the carpet aside.

2. Mark the rear shock absorber that is not being removed relative to the protective sleeve with the vehicle in a static, level ground position (curb height).





3. Remove the wheel and tire.

4. NOTICE: Do not support the rear axle at the differential housing or damage to the housing may occur.

NOTICE: Do not allow the axle assembly to hang supported only by the upper control arm or lower control arms. This could damage the control arm bushings.

Using 2 suitable jackstands, support the rear axle.

5. Remove and discard the shock absorber upper nut, washer and insulator assembly.
- To install, tighten the new nut to 40 Nm (30 lb-ft).

6. Raise the rear axle so the mark made on the rear shock absorber in Step 2 lines up with the protective sleeve.





7. Remove and discard the shock absorber lower bolt and nut and remove the shock absorber.
- To install, tighten the new bolt to 115 Nm (85 lb-ft).

8. NOTICE: Tighten the shock absorber lower bolt while the suspension is at curb height or bushing damage and incorrect clamp load may occur.

To install, reverse the removal procedure.