Ignition Coil

Ignition Coil

Removal and Installation

1. Disconnect the electrical connector from the ignition coil.

2. NOTICE: It is important to twist the spark plug wire boots while pulling upward to avoid possible damage to the spark plug wires.

NOTE: Spark plug wires must be connected to the correct ignition coil terminal.

Disconnect the 6 spark plug wires from the ignition coil.

3. Remove the 4 bolts and the ignition coil.
- To install, tighten to 6 Nm (53 lb-in).

4. NOTE: Be sure to reinstall the radio ignition interference capacitor under the correct mounting bolt.

To install, reverse the removal procedure.