Brake Caliper Anchor Plate

Brake Caliper Anchor Plate - 4.0L SOHC and 4.6L (3V)





Removal and Installation

1. Remove the brake pads. For additional information, refer to Brake Pads - 4.0L SOHC and 4.6L (3V) Brake Pads.

2. NOTE: Using specified brake cleaner, clean any residual threadlock compound from the anchor plate threads before installing the bolts.

Remove and discard the 2 anchor plate bolts and remove the brake caliper anchor plate.

- To install, tighten new anchor plate bolts to 115 Nm (85 lb-ft).

3. Inspect the brake caliper anchor plate assembly.
- Check the guide pins and boots for binding and damage.

- Replace worn or damaged pins. Lubricate the pins with the specified grease.

- Install a new brake caliper anchor plate if it is worn or damaged.

4. To install, reverse the removal procedure.