Bumper - Front

Bumper - Front

Removal and Installation

1. Remove the front bumper cover. For additional information, refer to Bumper Cover - Front Removal and Replacement.

2. Remove the 4 front bumper isolator pin-type retainers and the front bumper lower outer and upper center inner isolators.

3. Drill out the 6 front bumper spot welds.

4. Remove the front bumper bolts and the front bumper.
- To install, tighten to 25 Nm (18 lb-ft).

5. NOTE: Spot welding the bumper is not required for installation.

To install, reverse the removal procedure.