Pinpoint Test B: The Anti-Theft System Does Not Arm/Disarm - Using The Remote Keyless Entry (RKE) Transmitter

Anti-Theft

Pinpoint Tests

Pinpoint Test B: The Anti-Theft System Does Not Arm/Disarm - Using The Remote Keyless Entry (RKE) Transmitter

Normal Operation

The Smart Junction Box (SJB) receives lock/unlock commands from the Remote Keyless Entry (RKE) transmitter. The SJB then arms/disarms the perimeter alarm system as requested.

This pinpoint test is intended to diagnose the following:
- RKE transmitter
- SJB



PINPOINT TEST B: THE ANTI-THEFT SYSTEM DOES NOT ARM/DISARM - USING THE REMOTE KEYLESS ENTRY (RKE) TRANSMITTER

-------------------------------------------------
B1 CHECK THE RKE TRANSMITTER FOR CORRECT DOOR LOCK OPERATION


- Lock and unlock the door locks using the RKE transmitter.
- Do the door locks operate correctly?

Yes
GO to B2.

No
REFER to Locks.

-------------------------------------------------
B2 CHECK FOR CORRECT SJB OPERATION


- Disconnect all the SJB connectors.
- Check for:
- corrosion
- damaged pins
- pushed-out pins
- Connect all the SJB connectors and make sure they seat correctly.
- Operate the system and verify the concern is still present.
- Is the concern still present?

Yes
INSTALL a new SJB. TEST the system for normal operation.

No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. TEST the system for normal operation.

-------------------------------------------------