Accessory Drive Belt Tensioner

Accessory Drive Belt Tensioner

Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.

2. Remove the 4 screws and position the RH fender splash shield aside.





3. Remove the 6 pin-type retainers and the RH splash shield.

4. Using the hex feature, rotate the accessory drive belt tensioner clockwise and remove the accessory drive belt from the coolant pump pulley.





5. NOTE: The accessory drive belt tensioner must be replaced as a complete unit.

Remove the 2 bolts and the accessory drive belt tensioner.

- To install, tighten to 25 Nm (18 lb-ft).

6. To install, reverse the removal procedure.