Wiper Mounting Arm and Pivot Shaft

WIPER MOUNTING ARM AND PIVOT SHAFT

Removal and Installation
1. Park the wiper pivot arms in the highest position on the glass.
2. Disconnect the battery ground cable.
3. Remove the wiper pivot arm nut covers.
4. Remove the nuts and the wiper pivot arms.
- To install, tighten to 40 Nm (30 lb-ft).

5. Remove the cowl top vent panels.
6. Remove the 4 bolts, wiper mounting arm and wiper pivot shaft assembly.
- Disconnect the electrical connector.
- To install, tighten to 12 Nm (9 lb-ft).

7. To install, reverse the removal procedure.
- Adjust the wiper pivot arms. Refer to Wiper Blade and Pivot Arm Adjustment. Adjustments