Selector Lever Cable Adjustment -Column Shift
Selector Lever Cable Adjustment - Column ShiftNOTE: The selector lever cable adjustment procedure must be carried out in the order shown.
1. Position the transaxle range selector lever in OVERDRIVE. Hang a 1.4 kg (3 lb) weight on the lever.
2. Loosen the manual control lever-to-selector lever cable nut.
3. Position the manual control lever in OVERDRIVE then install the nut.
^ Tighten to 20 Nm (15 ft. lbs).
4. Remove the 1.4 kg (3 lb) weight. Check the operation of the transaxle in each transaxle range selector lever position.