Ignition Coil: Service and Repair

"AllData Editors Note:

Customers have reported success using the following spark plug wire placement on the coil pack."






IGNITION COIL

Engine Ignition Components - Exploded View:

Exploded View

Removal and Installation

1. CAUTION:
- It is important to twist the spark plug wire boots while pulling upward to avoid possible damage to the spark plug wire.
- Spark plug wires must be connected to the correct ignition coil terminal.

Disconnect the 6 spark plug wires from the ignition coil by twisting while pulling upward.

2. Disconnect the ignition coil electrical connector.
3. Remove the 3 bolts and the ignition coil.
- To install, tighten to 6 Nm (53 lb-in).

4. To install, reverse the removal procedure.