Instrument Panel Center Finish Panel

INSTRUMENT PANEL CENTER FINISH PANEL







Removal and Installation
1. Disconnect the battery ground cable. Service and Repair
2. Apply the parking brake.
3. If equipped with a floor selector lever, position the selector lever in the 1 position.
4. Remove the integrated control panel (ICP). Remote Control
5. Remove the 2 bolts and instrument panel lower steering column cover.
- To install, tighten to 9 Nm (80 lb-in)

6. Remove the ashtray.

7. NOTE: When installing the instrument panel center finish panel, be sure the alignment tabs are positioned correctly.

Remove the 7 screws and remove the instrument panel center finish panel.
- Disconnect the electrical connector by reaching through the ICP opening.

8. To install, reverse the removal procedure.