Sunroof / Moonroof Motor: Service and Repair

ROOF OPENING PANEL MOTOR

Part 1:

Part 2:

Exploded View

Removal

1. NOTE: If possible, make sure the roof opening panel glass is in the closed position.

Remove the roof opening panel motor access panel.

2. Disconnect the roof opening panel motor electrical connector.
3. Remove the 3 screws and the roof opening panel motor.

Installation
1. Connect the electrical connector to the roof opening panel motor.

2. NOTE:
- When installing the roof opening panel motor, it may be necessary to turn the roof opening panel motor slightly to engage the drive splines.
- Make sure the lifter arms and guide ramps are aligned.

Install the roof opening panel motor and the 3 screws.
- Tighten to 3 Nm (27 lb-in).

3. Install the roof opening panel motor access panel.
4. Initialize the roof opening panel motor.