Transmission Mount: Service and Repair

Transmission Rear Support Insulator

Transmission Rear Support Insulator Exploded View:

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Using a suitable transmission jack, support the transmission.
3. Loosen the 2 transmission rear support insulator nuts.





4. Remove the 4 transmission mount outer bolts.
^ To install, tighten to 63 Nm (46 ft. lbs).
5. Remove the transmission rear insulator center bolt. Carefully pry the exhaust brackets from the exhaust insulators on the rear transmission mount. Remove the transmission mount.
^ To install, tighten to 70 Nm (52 ft. lbs).
6. Remove the 2 transmission rear support insulator nuts. Separate the transmission rear support insulator from the transmission mount.
7. To install, reverse the removal procedure.