Extension Housing Seal

Extension Housing Seal

Special Tool(s):

Removal
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Remove the driveshaft.
3. Using a suitable transmission jack, support the transmission.
4. Remove the 4 transmission crossmember-to-floor pan screws only and lower the transmission enough to gain access to the extension housing seal.





5. Remove and discard the nut.





6. Using the special tool, remove the output shaft flange.





7. Using the special tools, remove and discard the extension housing seal.





Installation

1. NOTE: Make sure the extension housing seal is correctly installed onto the special tool and the garter spring is in the correct position.

Using the special tool, install the new extension housing seal.





2. Using the special tools, install the output flange.





3. Install a new nut.
^ Tighten to 130 Nm (96 ft. lbs).





4. Install the 4 transmission crossmember-to-floor pan screws only.
^ Tighten to 63 Nm (46 ft. lbs).





5. Install the driveshaft.
6. Check the transmission fluid level.