Power Seat Switch: Service and Repair

LUMBAR CONTROL SWITCH

Front Seat Backrest (Part 1):

Front Seat Backrest (Part 2):

Driver Power Front Seat Cushion (Part 1):

Driver Power Front Seat Cushion (Part 2):

Driver Manual Front Seat Cushion (Part 1):

Driver Manual Front Seat Cushion (Part 2):

Passenger Manual Front Seat Cushion (Part 1):

Passenger Manual Front Seat Cushion (Part 2):

Passenger Power Front Seat Cushion (Part 1):

Passenger Power Front Seat Cushion (Part 2):

Exploded View

Removal and Installation

WARNING:
- Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an airbag module. This will reduce the risk of injury in the event of an accidental deployment.
- To reduce the risk of personal injury, do not use any memory saver devices.

NOTE:
- If a seat equipped with a supplemental restraint system (SRS) component is being serviced, the supplemental restraint system (SRS) must be depowered.
- The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

1. Depower the SRS.
2. Remove the clip and the recline handle.
3. Remove the screw at the rear of the cushion side shield. Pull out on the side of the cushion side shield, release the retaining clips and pin-type retainer and separate the side shield.
4. Disconnect the lumbar control switch.
5. Release the retainers and remove the lumbar control switch from the cushion side shield.

6. CAUTION: Inspect the cushion side shield retaining clips for damage. Install new retainers if damage is present.

To install, reverse the removal procedure.

7. Repower the SRS.