Supercharger Bypass Vacuum Actuator

SUPERCHARGER BYPASS VACUUM ACTUATOR







Removal
1. Remove the throttle body.
2. Disconnect the 2 supercharger bypass vacuum actuator vacuum connectors.
3. Remove the 2 supercharger bypass vacuum actuator bolts.







4. Rotate the supercharger bypass vacuum actuator to align the actuator rod with the slot in the linkage, and remove the actuator.

Installation







1. CAUTION: The actuator adjustment tool included with the new actuator kit must be used when installing the supercharger bypass vacuum actuator. Failure to correctly adjust the actuator will result in incorrect operation of the supercharger assembly.

Install the adjustment tool on the motor, making sure the tool is correctly attached to the actuator rod.







2. Align the actuator rod with the slot in the linkage, and rotate the supercharger bypass vacuum actuator into position.
3. Install the 2 supercharger bypass vacuum actuator bolts.
- Tighten to 20 Nm (15 lb-ft).

4. Connect the 2 supercharger bypass vacuum actuator vacuum connectors.
5. Remove the adjustment tool.
6. Install the throttle body.