Air Cleaner Housing: Service and Repair

AIR CLEANER

Part 1:

Part 2:

Part 1:

Part 2:

Part 1:

Part 2:

Removal and Installation
1. Loosen the clamp and disconnect the air cleaner outlet pipe from the air cleaner assembly.
- To install, tighten to 3 Nm (27 lb-in).

2. Disconnect the mass air flow (MAF) sensor electrical connector.
3. Remove the air cleaner assembly bolt.
- To install, tighten to 8 Nm (71 lb-in).

4. NOTE: Make sure that the 2 rubber grommets are retained to the air cleaner assembly feet.

Remove the air cleaner assembly.

5. NOTE:
- Make sure that the 2 air cleaner assembly feet rubber grommets are seated into the locating holes in the fender.
- The air cleaner outlet pipe should be securely sealed to prevent unmetered air from entering the engine.

To install, reverse the removal procedure.