Oil Cooler: Service and Repair

Oil Cooler

Material:

Removal
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Drain the engine cooling system.
3. Remove the generator.

4. CAUTION: If metal or aluminum foreign material is present in the oil cooler, mechanical concerns exist. To diagnose mechanical concerns, refer to Engine.

Remove the 6 bolts and the oil cooler.
- Discard the gaskets.
- Inspect the oil cooler.

Installation

1. NOTE: Clean the sealing surfaces with metal surface prep. Follow the directions on the packaging. Inspect the mating surfaces.

Using new gaskets, install the oil cooler and the 6 bolts.
- Tighten in the sequence shown to 10 Nm (89 inch lbs.).





2. Install the generator.
3. Fill and bleed engine cooling system.