Engine Cooling

Radiator

Radiator:

Removal and Installation
1. Drain the cooling system.
2. Remove the lower radiator air deflector.
3. Remove the 6 pushpin retainers and the air deflector.





4. Remove the cooling fan motor and shroud.
5. Disconnect the degas bottle-to-radiator hose and position aside.
6. Disconnect the upper radiator hose from the radiator and position aside.
7. Disconnect the lower radiator hose from the radiator and position aside.
8. Remove the 4 bolts and the radiator support brackets.
- To install, tighten to 10 Nm (89 inch lbs.).
9. Remove the 2 power steering tubes and A/C condenser retaining nuts and position aside the power steering tubes.
- To install, tighten to 8 Nm (71 inch lbs.).
10. Remove the 2 A/C condenser bolts.
- To install, tighten to 10 Nm (89 inch lbs.).
11. If equipped, remove the 2 bolts and the transmission cooler and position aside.
- To install, tighten to 10 Nm (89 inch lbs.).
12. Remove the radiator.
13. To install, reverse the removal procedure.
14. Fill and bleed the cooling system.