Parking Brake Control: Service and Repair

Parking Brake Control

Removal and Installation

Parking Brake - Exploded View:

1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the floor console.
3. Release the tension on the parking brake cable.
4. Disconnect the front parking brake cable from the 2 rear parking brake cables at the equalizer and release the front cable from the body bracket.





5. Disconnect the parking brake switch electrical connector.
6. Remove the 2 nuts from the parking brake control.
- To install, tighten to 17 Nm (13 ft. lbs.).
7. Remove the 2 bolts from the parking brake control.
- To install, tighten to 30 Nm (22 ft. lbs.).
8. Remove the parking brake control.
- Position the cable and equalizer through the floorpan.
9. To install, reverse the removal procedure.
- Adjust the parking brake cable tension.