Removal and Replacement

Parking Brake Cable - Rear

Removal and Installation

Parking Brake - Exploded View:

All vehicles
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Release the tension on the parking brake cable.

Convertible vehicles
3. Remove and discard the appropriate support brace rear bolts.
- To install, tighten to 63 Nm (46 ft. lbs.).





4. Remove and discard the appropriate support brace upper bolts.
- To install, tighten to 63 Nm (46 ft. lbs.).





5. Remove and discard the appropriate support brace front bolts.
- To install, tighten to 63 Nm (46 ft. lbs.).





All vehicles
6. Disconnect the appropriate rear parking brake cable from the front parking brake cable at the equalizer, and release the cable from the body bracket.





7. CAUTION: Verify that the boot is attached to the conduit end fitting and the strand end fitting. A clamp must be secured on the strand end fitting (t-end). There should be no exposed strand at the wheel end of the parking brake cable.

Remove the parking brake cable retaining clip from the parking brake cable and disconnect the rear parking brake cable from the brake caliper.





8. Remove the parking brake cable bracket bolt.
- To install, tighten to 27 Nm (20 ft. lbs.).
9. If removing the RH cable, remove the parking brake cable crossmember bracket bolt.
- To install, tighten to 20 Nm (15 ft. lbs.).
10. To install, reverse the removal procedure.
- Adjust the parking brake cable tension.