Brake Caliper Support Bracket

Brake Caliper Support Bracket

Removal and Installation

Disc Brake System - Exploded View:

1. Remove the rear axle shaft.
2. Remove the 3 bolts and the brake disc shield.
- To install, tighten to 20 Nm (15 ft. lbs.).

3. NOTE: Make sure the anti-moan bracket holes, the brake caliper support bracket and the brake caliper anchor plate holes line up during installation.

Remove the anti-moan bracket.
- To install, tighten to 35 Nm (26 ft. lbs.).
4. Remove the 4 brake caliper support bracket nuts, bolts and the bracket.
- To install, tighten to 68 Nm (50 ft. lbs.).
5. To install, reverse the removal procedure.