Rear Bumper Cover / Fascia: Service and Repair

BUMPER COVER - REAR

Part 1:

Part 2:

Exploded View

Removal and Installation
1. Remove the 4 pin-type retainers and the luggage compartment trim panel.
2. Remove the 4 rear bumper cover-to-bumper cover bracket screws.

3. NOTE: GT vehicles are equipped with 3 pin-type retainers.

If equipped, remove the 3 rear bumper cover pin-type retainers.

4. From inside the luggage compartment, remove the 4 rear bumper cover nuts.
- To install, tighten to 5 Nm (44 lb-in).

5. Disconnect the electrical connector from inside the luggage compartment and remove the rear bumper cover.
- Feed the rear bumper electrical harness through the rear of the vehicle.

6. To install, reverse the removal procedure.
- Transfer components as needed.