Front Bumper Cover / Fascia: Service and Repair
BUMPER COVER - FRONTBase Vehicle And GT (Part 1):
Base Vehicle And GT (Part 2):
SheIby GT 500 (Part 1):
SheIby GT 500 (Part 2):
Exploded View
Removal and Installation
Base vehicle and GT
1. Remove the 6 pin-type retainers and the upper radiator sight shield.
Shelby GT 500
2. Remove the 8 pin-type retainers and the upper radiator sight shield.
All vehicles
3. Remove the 2 upper front bumper cover bolts.
4. Remove the 6 front fender splash shield-to-front bumper cover screws.
5. If equipped, remove the 4 lower air deflector screws.
6. Position the front splash shield aside and remove the 4 front bumper cover-to-reinforcement nuts.
- To install, tighten to 5 Nm (44 lb-in).
7. If equipped, disconnect the 2 fog lamp electrical connectors.
8. Disconnect the 4 side marker lamp electrical connectors and remove the front bumper cover.
9. To install, reverse the removal procedure.