Engine Mount - LH
Engine Mount - LHSpecial Tool(s):
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery ground cable.
3. Remove the throttle body (TB).
4. Remove the front end accessory drive (FEAD) bracket bolt and install the special tool.
- To install, tighten to 48 Nm (35 ft. lbs.).
5. Remove the 6 pin-type retainers and the radiator sight shield.
6. Install the special tools.
7. Remove the engine mount bracket-to-engine mount nut.
- To install, tighten to 63 Nm (46 ft. lbs.).
8. Remove the 3 engine mount bracket nuts and remove the bracket.
- To install, tighten to 80 Nm (59 ft. lbs.).
9. Remove the 2 engine mount bolts and the engine mount.
- To install, tighten to 70 Nm (52 ft. lbs.).
10. To install, reverse the removal procedure.