Principles of Operation

PRINCIPLES OF OPERATION

When the hazard lamp function is selected, the multifunction switch routes voltage to the electronic flasher. The electronic flasher then routes voltage back to the multifunction switch, which in turn routes voltage to all the turn lamps. The electronic flasher cycles at a rate of approximately 80 times per minute. If a bulb has failed, the electronic flasher will cycle at approximately 160 times per minute.

When a turn signal function is selected, voltage is routed to the LH or RH turn lamps. The electronic flasher cycles at a rate of approximately 80 times per minute. If a bulb has failed, the electronic flasher will cycle at approximately 160 times per minute.