Principles of Operation

PRINCIPLES OF OPERATION

The speed control system is designed to maintain a set vehicle speed above 48 km/h (30 mph). After the speed control ON switch is pressed, pressing the speed control SET/ACCEL switch will activate the speed control actuator. To increase a set speed, either press and hold SET/ACCEL for continuous acceleration, or momentarily tap SET/ACCEL for 1.6 km/h (1 mph) acceleration increments. To decrease a set speed, press and hold the speed control COAST switch until the target speed is reached, or momentarily tap COAST for 1.6 km/h (1 mph) deceleration increments. When the speed control system has been disabled by tapping the brake pedal, the speed control RESUME switch can be pressed and the vehicle will return to the original set speed if the vehicle is traveling over 48 km/h (30 mph) and the speed control OFF switch has not been pressed.

NOTE:
- The deactivator switch is provided as an additional safety feature. Normally, when the brake pedal is pressed, an electrical signal from the brake lamp circuit to the speed control actuator will deactivate the system. Under increased brake pedal effort, the deactivator switch will open and remove power to the speed control actuator, releasing the throttle independently of the speed control actuator.
- The clockspring provides the electrical interface between the steering column wiring and the speed control switches in the steering wheel.

The inputs to the speed control actuator are:
- Vehicle speed signal
- Speed control switches
- Stoplamp switch
- Deactivator switch

The outputs of the speed control actuator are:
- Speed control indicator lamp
- Speed control actuator cable controlling the throttle position