Removal and Replacement

PARCEL SHELF

Removal and Installation







1. NOTE: Insert two thin bladed 20 mm (0.8 in) wide tools approximately 60 mm (2.36 in) [2.4 in] from the outside edges of the high mount stop LED module.

Push rearward to disengage the retaining clips and lift the front of the high mount stop LED module from the parcel shelf.
- Disconnect the electrical connector and remove the high mount stop LED module.

2. Remove the rear seat backrest and the rear seat cushion.
3. Remove the LH and RH roof trim panels.
4. Remove the 2 pin-type retainers and the parcel shelf.
5. To install, reverse the removal procedure.