Ignition Coil: Service and Repair

IGNITION COIL

Engine Ignition Components - Exploded View (Part 1):

Engine Ignition Components - Exploded View (Part 2):

Exploded View

Removal and Installation
1. Disconnect the battery ground cable.
2. Disconnect the electrical connector from the ignition coil.

3. CAUTION:
- It is important to twist the spark plug wire boots while pulling upward to avoid possible damage to the spark plug wires.
- Spark plug wires must be connected to the correct ignition coil terminal.

Disconnect the 6 spark plug wires from the ignition coil.

4. Remove the 4 bolts and the ignition coil.
- To install, tighten to 6 Nm (53 lb-in).

5. NOTE: Be sure to reinstall the radio ignition interference capacitor under the correct mounting bolt.

To install, reverse the removal procedure.