Removal and Installation

SPARK PLUGS

Engine Ignition Components - Exploded View (Part 1):

Engine Ignition Components - Exploded View (Part 2):

Exploded View

Special Tool(s):

Special Tool(s)

Removal
1. Disconnect the battery ground cable.







2. CAUTION:
- Spark plug wires must be connected to the correct spark plug.
- It is important to twist the spark plug wire boots while pulling upward to avoid possible damage to the spark plug wire.

Using the special tool, remove the spark plug wires from the spark plugs using a twisting motion.

3. NOTE: Use compressed air to remove any foreign material in the spark plug well before removing the spark plugs.

Remove the 6 spark plugs.

Installation
1. Install the 6 spark plugs.
- Tighten to 17 Nm (13 lb-ft).

2. Apply Silicone Brake Caliper Grease and Dielectric Compound, XG-3-A, ESE-M1C171-A or equivalent to the inside of the spark plug wire-to-boots.

3. CAUTION: Make sure the spark plug boots are positioned so that the spark plug wires do not contact the exhaust manifold, or any sharp edges.

Connect the 6 spark plug wires to the spark plugs.

4. Connect the battery ground cable.