Brake Switch (Cruise Control): Service and Repair

SPEED CONTROL DEACTIVATOR SWITCH

Speed Control Deactivator Switch - Brake Pedal:

Speed Control Deactivator Switch - Clutch Pedal:

Removal and Installation

NOTE: This procedure is for both speed control deactivator switches.

1. CAUTION: Do not press the pedal when removing or installing the speed control deactivator switch, as the switch will be damaged.

Remove the speed control deactivator switch.
- Disconnect the electrical connector.
- Rotate the speed control deactivator switch counterclockwise 45 degrees and remove the deactivator switch.

2. NOTE: When installing the speed control deactivator switch it is automatically self-adjusting to the proper position. Do not pull up or push down on the pedal during installation. Initial installation of the speed control deactivator switch allows for one adjustment. If additional adjustments are necessary, install a new switch.

To install, reverse the removal procedure.