Seat Track - Power

SEAT TRACK - POWER

Removal and Installation

WARNING:
- Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an airbag module. This will reduce the risk of injury in the event of an accidental deployment.
- To reduce the risk of personal injury, do not use any memory saver devices.

NOTE:
- If a seat equipped with a supplemental restraint system (SRS) component is being serviced, the supplemental restraint system (SRS) must be depowered.
- The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

All seats
1. Position the seat to gain access to the seat track-to-floor nuts and bolts.
2. Depower the SRS.
3. Remove the front seat.
4. Remove the clip and the recline handle.
5. Remove the screw at the rear of the cushion side shield. Pull out on the side of the cushion side shield, release the retaining clips and pin-type retainer and separate the side shield.

Seats with side air bags

6. NOTE: Note wire harness routing for installation.

Separate the side air bag module electrical connector and wire harness from the power seat track bracket.

All seats
7. Release the cushion trim cover rear J-clip, disconnect the power lumbar electrical connector and separate it from the cushion frame.

8. NOTE: Note wire harness routing for installation.

Disconnect the power seat track motor electrical connector, separate the main seat electrical connector and wire harness from the power seat track bracket and position the wire harness aside.

9. NOTE: Note wire harness routing for installation.

Disconnect the safety belt buckle switch and the seat position sensor (driver seat) and separate the pin-type retainers from the seat track.

10. Release all cushion trim cover to cushion frame retainers.
11. Remove the 4 nuts and the power seat track.
- Lift the cushion foam pad to access the power seat track nuts.
- To install, tighten to 36 Nm (27 lb-ft).

12. Remove the bolt and safety belt buckle.
- To install, tighten to 42 Nm (31 lb-ft).

13. To install, reverse the removal procedure.
14. Install the seat.
15. Repower the SRS.