Parking Brake Control: Service and Repair

Parking Brake Control

Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Remove the LH front seat. For additional information, refer to Seats.
3. Remove the floor console. For additional information, refer to Dashboard.
4. Release the tension on the parking brake cable.





5. Disconnect the front parking brake cable from the 2 rear parking brake cables at the equalizer and release the front cable from the body bracket.
6. Disconnect the parking brake switch electrical connector.
7. Remove the 2 nuts from the parking brake control.
^ To install, tighten to 17 Nm (13 ft. lbs.).
8. Remove the 2 bolts from the parking brake control.
^ To install, tighten to 30 Nm (22 ft. lbs.).
9. Remove the parking brake control.
^ Position the cable and equalizer through the floorpan.
10. To install, reverse the removal procedure.
^ Adjust the parking brake cable tension.