Front Bumper Reinforcement: Service and Repair

FRONT BUMPER

Part 1:

Part 2:

Exploded View

Removal and Installation
1. Remove the front bumper cover.
2. Remove the 4 pin-type retainers and the front bumper isolator.
3. Drill out the 6 front bumper spot welds.
4. Remove the 8 bolts and the front bumper.
- To install, tighten to 25 Nm (18 lb-ft).

5. NOTE: Spot welding the bumper is not required for installation.

To install, reverse the removal procedure.