RH

Exhaust Manifold - RH








Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the RH catalytic converter.
3. Disconnect the HO2S electrical connector.
4. Remove the 3 bolts and the RH exhaust manifold heat shield
^ To install, tighten to 11 Nm (8 ft. lbs.).
5. Disconnect the EGR system module tube from the exhaust manifold.
^ To install, tighten to 40 Nm (30 ft. lbs.).
6. Remove the 6 nuts and the RH exhaust manifold.
^ To install, tighten to 20 Nm (15 ft. lbs.).
^ Remove and discard the exhaust manifold gasket.

7. NOTE: Make sure to install a new exhaust manifold gasket.

To install, reverse the removal procedure.