Torque Specifications

Cylinder Head





CAUTION: Always install new cylinder head bolts.

NOTE: Lubricate the cylinder head bolts with engine oil prior to installation.

Install the cylinder head assembly and tighten the cylinder head bolts in the following sequence.
1. Tighten all bolts in a single sequence to 50 Nm
2. Back the bolts off 1/2 turn.
3. Tighten the bolts in sequence shown to 50 Nm.
4. Rotate all the bolts in a single sequence an additional 180 degrees in two steps of 90 degrees each.

Camshaft Thrust Plate
Tighten to 10 Nm.


Camshaft Pulley
Tighten to 105 Nm.


Intake Manifold
Tighten the nuts and bolts to 10 Nm and 90 degrees.


Exhaust Manifold
Tighten to 27 Nm.