Removal and Installation

Special Tools:

Removal

NOTE: The power steering pump is serviced as an assembly. If any service is required the entire power steering pump assembly must be replaced.

1. Disconnect battery ground cable.
2. Remove drive belt.
3. Disconnect power steering pressure hose from power steering pump and drain the fluid into a container.
4. Remove power steering reservoir pump hose from between power steering pump and power steering pump reservoir. Drain fluid into a container.
5. Remove three retaining bolts and remove power steering pump.
6. Remove retaining nut on power steering pump pulley. Remove power steering pump pulley from power steering pump.

Installation

1. Follow removal procedure in reverse order.
2. Fill power steering pump reservoir to proper level with Motorcraft MERCON Multi-Purpose (ATF) Transmission Fluid XT-2-QDX or equivalent meeting Ford MERCON specification.