Gasoline

Removal
1. Disconnect battery ground cable.
2. Position the power distribution box out of the way.
3. Remove the engine outlet tube.
4. Disconnect power steering pressure hose from power steering pump.
5. Remove the nut from the exhaust manifold stud.
6. Remove the nut from the transmission stud.
7. Disconnect the Power Steering Pressure (PSP) switch electrical connector.
8. Disconnect the power steering pressure hose from the steering gear.
9. Remove the power steering pressure hose. Remove and discard the seals.

Installation
1. Follow removal procedure in reverse order.
2. Using Teflon Seal Replacer 211-D027 (D9OP-3517-A), install new seals on the power steering pressure hose.
3. Fill and bleed power steering system with Motorcraft MERCON(r) Multi-Purpose ATF XT-2-QDX or MERCON(r) equivalent. Check system for leaks and proper operation.