Cylinder Block

Disassembly
1. Mount the engine in a workstand and remove all parts not furnished with the new cylinder block, following the procedures in Removal and Installation.
2. Remove the four cylinder head to block dowels and the cylinder block drain plugs.
3. Remove the used cylinder block from the workstand.

Assembly
1. Clean the gasket and seal surfaces of all serviceable parts and assemblies.
2. Position the new cylinder block in a workstand and install the cylinder head to block dowels and block cylinder drain plugs.
3. Transfer all serviceable parts removed from the used cylinder block, following the procedures in Removal and Installation.
4. Check all assembly clearances and correct as necessary.