Cruise Control Servo: Service and Repair

REMOVAL







1. Disconnect speed control cable fitting from throttle body by pulling lever arm up and off.
2. Raise vehicle.
3. Remove LH front wheel and front fender splash shield.
4. Disconnect harness connector at speed control servo.
5. Remove two screws retaining speed control servo to vehicle.
6. Lower vehicle.







7. Remove speed control cable cap from speed control servo by pressing cap locking arm and rotating speed control cable cap counterclockwise.







8. Remove speed control cable slug from speed control servo pulley. Gently push actuator cable slug past retaining spring using a small screwdriver.







9. Remove three screws holding speed control servo to speed control servo bracket.

INSTALLATION
1. Install speed control servo to speed control servo bracket. Tighten screws to 6-7 N.m (53-62 lb-in).
2. Make sure that rubber seal is snug against speed control actuator cable cap.
3. Lock speed control actuator cable ball slug into speed control servo pulley slot.

NOTE: Incorrect wrapping of speed control actuator cable core wire around speed control servo pulley may result in a high idle condition. Make sure throttle lever is at idle position after speed control cable installation and cable adjustment.

4. Pull on throttle attachment end of speed control actuator cable to draw speed control actuator cable cap on to speed control servo pulley.
5. Insert speed control actuator cable cap locking tabs into speed control servo slots. Rotate cap clockwise until cap locking arm engages cap locking tab on speed control servo.
6. Position speed control cable and speed control servo in vehicle. Tighten mounting screws to 5.2-7.2 N.m (46-63 lb-in).
7. Attach harness connector to speed control servo.
8. Reinstall front fender splash shield and LH front wheel.
9. Adjust speed control cable.