Removal and Installation

Removal and Installation

Note:

The power steering pump is serviced as an assembly. If any service is required the entire power steering pump assembly must be replaced.

1. Disconnect battery ground cable.

2. Remove drive belt.

3. Disconnect power steering pressure hose from power steering pump and drain the fluid into a container.

4. Remove power steering reservoir pump hose from between power steering pump and power steering pump reservoir. Drain fluid into a container.

5. Remove three retaining bolts and remove power steering pump.

6. Remove retaining nut on power steering pump pulley. Remove power steering pump pulley from power steering pump.

7. To install, reverse Removal procedure.

8. Fill power steering pump reservoir to proper level with Premium Power Steering Fluid or equivalent meeting Ford specification ESW-M2C33-F.