Evaporative Emission Control Canister: Service and Repair

Evaporative Emission Canister:

Removal
1. Raise vehicle on hoist.

2. Disconnect the evaporative emission canister vent tube from the secondary vent hose at fuel filler neck.

3. Disconnect electrical connector from the evaporative emission canister vent solenoid.

4. Remove evaporative emission canister retaining bolts and nuts.

5. Partially lower evaporative emissions canister (EVAP canister) and disconnect fuel tank vent tube from evaporative emissions canister.

Installation
1. Follow removal procedure in reverse order.

2. Tighten evaporative emission canister retaining bolts and nuts to: 6-7 Nm (54-61 lb.in)
3. Perform system leak check. Evaporative Emission Canister Assembly Leak Test