Canister Purge Control Valve: Service and Repair

Evaporative Emission System Components:

Removal
1. Disconnect main emission vacuum control connector from connector port on evaporative emission canister purge valve (EVAP canister purge valve).

2. Disconnect fuel and vapor return tube and evaporative emission return tube from the evaporative emission canister purge valve.

3. Disconnect the engine control sensor wiring from the evaporative emission canister purge valve.

4. Remove evaporative emission canister purge valve retaining nuts and evaporative emission canister purge valve from dash panel.

Installation
1. Follow removal procedure in reverse order.

2. Tighten evaporative emission canister purge valve retaining nuts to: 8-10 Nm (71-88 lb in).

3. Perform system leak check: EVAP System Leak Test