Right Side

1. Disconnect battery ground cable.
2. Remove secondary air injection manifold tube from manifold.
3. Remove three bolts from heat shield.
4. Raise and support vehicle.
5. Remove EGR valve to manifold tube from manifold.
6. Disconnect EGR valve to manifold tube from EGR transducer.
7. Remove dual converter Y-pipe and lower manifold retaining nuts.
8. Lower vehicle and remove manifold heat shield.
9. Remove upper manifold retaining nuts.
10. Remove manifold and gasket.
11. Reverse procedure to install. Tighten exhaust manifold stud bolts to 11-19 ft lb, and exhaust manifold shield bolts to 12-16 ft lb.