Ignition Coil: Service and Repair

Removal

1. Disconnect electrical connectors from coil pack and capacitor.

Removing Ignition Wires At Coil Pack:

2. Disconnect spark plug wires by squeezing locking tabs and twisting while pulling upward.
3. Remove four coil pack retaining bolts and remove coil pack and capacitor. Save capacitor for installation with new coil pack.

Installation

Ignition Coil And Camshaft Position Sensor:

1. Position coil pack and capacitor to mounting bracket.
2. Install retaining bolts and tighten to 44-61 in lbs (5-7 Nm).
3. Apply silicone dielectric compound (D7AZ-19A331-A, or equivalent) to all spark plug wire boots.
4. Install each connector to the proper terminal on the coil pack. Make sure boots are fully seated.
5. Connect coil pack and capacitor electrical connectors.