Selector Lever Cable Adjustment - 6F50 and 6F55

Selector Lever Cable Adjustment - 6F50 and 6F55

WARNING: Before beginning any service procedure, REFER to Safety Warnings . Failure to follow this instruction may result in serious personal injury.

General Procedure

1. Disconnect the selector lever cable end from the manual control lever.





2. Place the selector lever in DRIVE.





3. Place the manual control lever in DRIVE.

1. Rotate the manual control lever clockwise until it stops.
2. Rotate the manual control lever counterclockwise one detent.






4. Unlock the adjuster.

1. Pry the latch up.
2. Push the lock tab to slide it over.






5. Slide the selector lever cable end forward or backward to align it with the manual control lever.





6. With the adjuster locking tab released, connect the selector lever cable end to the manual control lever.





7. NOTE: After locking the adjuster, pull back on the adjuster to make sure it is securely installed.
Slide the release tab back to lock the adjuster.





8. Verify the vehicle starts in PARK and NEUTRAL only and the reverse lamps illuminate in REVERSE.