Oil Pressure Sender: Service and Repair

Engine Oil Pressure (EOP) Switch

Material(s)






Removal

NOTE: Removal steps in this procedure may contain installation details.

1. With the vehicle in NEUTRAL, position it on a hoist. REFER to Jacking and Lifting

2. Loosen the 4 retainers and remove the underbody shield.





3. NOTE: Apply thread sealant to the EOP (Engine Oil Pressure) switch threads.
Disconnect the EOP (Engine Oil Pressure) switch electrical connector.

- Remove the EOP (Engine Oil Pressure) switch.
- To install, tighten to 15 Nm (133 lb-in).





Installation

1. To install, reverse the removal procedure.