Seating - 3rd Row

Power-Fold Seat Module (PFSM)

Removal

NOTE: For component identification and locations, REFER to Seat - Exploded View .

1. NOTE: If power seat is inoperative, REFER to Manual Override of Inoperative Power Seat - 3rd Row .
Position the LH (Left Hand) seat to the load floor position.





2. NOTICE: Do not lift the load floor flapper panel too far or damage to the wire harness retainers will occur.

Separate the LH (Left Hand) load floor support from the load floor panel.

- Push the load floor support rearward and slightly lift the load floor to disengage.






3. Slightly raise the LH (Left Hand) load floor flapper panel, pull up and detach the wire harness retainer attached to the load floor support studs.





4. Carefully lift the LH (Left Hand) load floor flapper panel, disconnect the electrical connectors, detach the retainers and remove the PFSM (Power-Fold Seat Module).





Installation

1. Carefully lift the LH (Left Hand) load floor flapper panel, install the PFSM (Power-Fold Seat Module), connect the electrical connectors and attach the retainers.

2. Slightly raise the LH (Left Hand) load floor flapper panel, attach the wire harness retainer to the load floor support studs.

3. Attach the LH (Left Hand) load floor support to the load floor panel.